What is it and why would a cuemaker have one?


Post the answer in the comment section here on my blog.  First correct answer gets a DP Tee Shirt.

Hint: Gravity at Work





Post your answer in the comment section here, not on Facebook.
DP

 
Posted by Dale Perry on June 10, 2014 at 10:17 AM under
• 19 comments
Comments

Comments

  1. eric on June 10, 2014 at 11:13 AM said:
    Holds pressure on floating center in headstock of your lathe.
  2. Chris firof on June 10, 2014 at 11:14 AM said:
    Looks like a loom for applying Irish linen
  3. Tom Penrose on June 10, 2014 at 11:18 AM said:
    Or is it to straighten a warped cue/shaft?
  4. Dale Perry on June 10, 2014 at 11:20 AM said:
    Nope !! / DP
  5. Dale Perry on June 10, 2014 at 11:20 AM said:
    Nope !! /DP
  6. Dale Perry on June 10, 2014 at 11:20 AM said:
    Nope !! /DP
  7. Robert on June 10, 2014 at 11:32 AM said:
    is it the feeding tube of a lathe
  8. Dale Perry on June 10, 2014 at 11:33 AM said:
    YES !!
  9. Jeremy Crutchfield on June 10, 2014 at 11:33 AM said:
    It is an automatic feed for turning shafts.
  10. Jeremy Crutchfield on June 10, 2014 at 11:33 AM said:
    It is an automatic feed for turning shafts.
  11. Phil on June 10, 2014 at 11:34 AM said:
    Applies pressure to secure tips onto shafts.
  12. Dale Perry on June 10, 2014 at 11:40 AM said:
    YES !!
  13. John Barnshaw on June 10, 2014 at 12:21 PM said:
    I thought it was for putting Irish Linen on a cue....
  14. Dale Perry on June 10, 2014 at 1:10 PM said:
    No, it is for pushing tube in a lathe for a cut off operation./DP
  15. Dale Perry on June 10, 2014 at 1:33 PM said:
    No, it is for pushing tube in a lathe for a cut off operation./DP
  16. Dale Perry on June 10, 2014 at 1:57 PM said:
    No, it is for pushing tube in a lathe for a cut off operation./DP
  17. Bernardo Kessel on June 10, 2014 at 2:05 PM said:
    It's the feeder
  18. Dale Perry on June 10, 2014 at 2:07 PM said:
    No, it is for pushing tube in a lathe for a cut off operation./DP
  19. Loren Lobdell on June 17, 2014 at 5:34 AM said:
    Too late but it is a feeding tube to a lathe
Leave a Comment: